Quick Starting To Use Nk-Nuc980 - Nuvoton NK-NUC980 Quick Start Manual

Hide thumbs Also See for NK-NUC980:

Table of Contents

QUICK STARTING TO USE NK-NUC980

This chapter will help users easily to use NK-NUC980 step by step.

1. Select USB ISP mode and enable the UART_0 message

NK-NUC980 provides jumpers (SW2) to select boot-up conditions. Select USB ISP mode and

enable the UART_0 message. The statuses of SW2.1, SW2.2, SW2.6 are ON.

2. Insert the 5V adapter (CON1)

3. Plug in the USB cable (CON33)

The burning tool requires a NuWriter driver to be installed on PC first. Please follow the steps below

to install the driver.

"WinUSB4NuVCOM.exe"

Run

the

"WinUSB4NuVCOM.exe" can be found in the "Tool" directory. Power on the NUC980 Series MPU

EVB and plug the USB cable into PC, the Windows shall find a new device and then request to

install its driver.

Dec 25, 2018

NK-NUC980 Quick Start Guide

before

the

USB

cable

Page 5 of 22

plugged

in.

The

Rev 1.00

Table of Contents