Table of Contents
Advertisement
II. Read Before Proceeding (continued)
DANGER
This appliance MUST NOT be installed in any location
where gasoline or flammable vapors are likely to be
present or, in an environment that contains corrosive
contaminants (see Table 4).
Do not block or restrict in any way the flow of combustion
or ventilation air from or to the appliance.
Do not use this appliance if any part has been under
water. Any appliance that has been under water must
be replaced. Water damage to the unit can be extensive
and present numerous safety hazards.
E. Gas Leakage (If you detect or smell gas...)
DANGER
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use any
phone in the building.
3. Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instruction.
4. If you cannot reach your gas supplier, call the fire
department.
F. Maintenance
1. To avoid electrical shock, ensure all electrical
connections are disconnected before attempting
installation or service of electrical components or
connections.
2. Lockout all electrical boxes with padlock once
power is turned off.
3. To prevent severe burns, allow the appliance to
cool before performing maintenance.
G. Product Identification Label
1. A nameplate, in accordance with the ASME code
Section IV, is permanently attached to the heat
exchanger.
2. To access the nameplate, remove front jacket panel
from the appliance.
DANGER
Should overheating occur or the gas supply fail to shut
off, turn off the manual gas control valve to the appli-
ance.
AMP 400-1000L I&O Manual
DANGER
DANGER
DANGER
H. Factory Test and Inspections
1. Prior to shipment, final air-fuel adjustments are
performed by factory trained service personnel
on each appliance. The factory emissions report
is posted on the back of the front jacket panel as
a reference for troubleshooting and maintenance.
2. In addition, the following tests and inspections
are performed to ensure the appliance meets our
highest safety and performance standards:
Operating test
Construction inspection
Electrical components inspection
Crating inspection.
I. Disclaimers and Local Codes
1. Installation must conform to the requirements of
the authority having jurisdiction. In the absence of
such requirements, installation must conform to
the National Fuel Gas Code, NFPA 54/ANSI Z223.1,
and/ or CSA B149.1 Natural Gas and Propane Code.
Where required by the authority having jurisdiction,
the installation must conform to the Standard for
Controls and Safety Devices for Automatically Fired
Boilers, ANSI/ ASME CSD-1.
2. Installation, start-up, and maintenance of this
equipment can be hazardous and requires trained,
qualified installers and service personnel. Do not
install, operate, service or repair any components
of this equipment unless you are qualified and fully
understand all requirements and procedures.
3. This instruction manual is an integral part of the
product and must be retained by the person in
charge of the appliance operation, service, and
maintenance.
WARNING
WARNING
This product can expose you to chemicals, includ-
ing chromium, which are known to the state of
California to cause cancer and birth defects or
other reproductive harm. For more information
go to: www. P65Warnings.ca.gov.
5
Advertisement
Table of Contents
