Table of Contents
Advertisement
•
Make sure that the work area is safe. Wet and loose
soil decreases safe operation of the product. Be very
careful on slopes and rough surfaces.
•
Make sure that all persons in the work area are
above the product on the slope.
•
Operate the product up and down the slope, not from
side to side.
•
Do not park the product on a slope. If you must park
the product on a slope, make sure that the product
cannot fall. There is a risk of injury and damage.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
•
Clean the product to remove dangerous material
before you do the maintenance.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the motor manual that is supplied by the motor
manufacturer.
•
Do the daily maintenance. Refer to
schedule on page 13 .
Battery status
The battery status indicator (A) comes on when the
product operates.
The battery status indicator is off when the product is
not in operation. The battery check button (B) must be
pushed for the battery status indicator to come on.
1661 - 002 - 13.03.2023
Read the warning
Operation
Read and understand the
Maintenance
•
Disconnect the product from the power source
before you do the maintenance.
•
Do not change the product. Modifications that are
not approved by the manufacturer can cause serious
injury or death.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
Replace damaged, worn or broken parts.
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
B
If there is an error with the battery, the "ALERT"
indicator (C) or the "ERROR" indicator (D) on the battery
"ALERT" and "ERROR" indicators
comes on. Refer to
on the battery on page 17 .
State of charge
Fully charged.
ALERT
ERROR
A
C
D
Symbol in the
status indicator
11
Advertisement
Table of Contents
