Operation - Husqvarna Blastrac EBE 500 Operator's Manual

• Do the maintenance of the product on stable level
ground. Make sure that the product cannot move.
• Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
• Replace damaged, worn or broken parts.
• Do not use a pressure washer to clean the product.
• Only use lint-free cleaning cloths.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust collector
carefully and make sure that you understand the
instructions.
3. If the product is operated in connection with a power
source, make sure that you read and understand the
operator's manual of that power source.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
5. Make sure that only approved persons are in the
work area.
6. Do daily maintenance. Refer to
schedule on page 19 .
7. Make sure that the product is assembled correctly
and is not damaged.
8. Make sure that all bolts, screws and nuts are
tightened.
9. Make sure that the blast wheel blades, feed spout,
and seals are not damaged or worn out. Replace
the parts when 75% of the blade thickness has been
worn away.
10. Make sure that the separator is not damaged.
11. Make sure that the separator is filled with abrasive
material up to the separator tray.
12. Make sure that the brush list seals are installed at
the correct height. Refer to
of the brush list seals on page 13 .
13. Install the side seals. Refer to
seals on page 13 .
14. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
12
Before you operate the
Maintenance
To set the correct height
To install the side
Transportation on page 27 .
by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.

Operation

15. Connect a dust collector to the product. Refer to
connect a dust collector on page 14 .
16. Make sure that the ON/OFF switch is in OFF position
before you connect the product to a power source.
17. Connect the product to a power source. Refer to
connect the product to a power source on page 15 .
Valve for the abrasive material
The valve for the abrasive material controls the flow of
the abrasive material to the blast wheel blades. The
adjustment of the valve for the abrasive material is
shown on the ammeter. Refer to
You can adjust the valve for the abrasive material with
the control lever for the abrasive material. Refer to
operate the valve for the abrasive material on page 12 .
To operate the valve for the abrasive
material
CAUTION:
abrasive material when the blast motor is in
operation.
1. Operate the control lever for the abrasive material
(A) to close the valve and stop the flow of abrasive
material.
A
B
Ammeter on page 11 .
To
Only open the valve for the
2107 - 001 - 27.07.2023
To
To