Advertisement
Available languages
Available languages
Safety instructions for operation on slopes
WARNING:
instructions that follow before you use the
product.
•
Do not operate the product on a slope that is more
than 20°. Loose ground, vibrations and the operation
speed can cause the product to fall on a slope that is
less than 20°.
•
Make sure that the work area is safe. Wet and loose
soil decreases safe operation of the product. Be very
careful on slopes and rough surfaces.
•
Make sure that all persons in the work area are
above the product on the slope.
•
Operate the product up and down the slope, not from
side to side.
•
Do not park the product on a slope. If you must park
the product on a slope, make sure that the product
cannot fall. There is a risk of injury and damage.
Safety instructions for operation near edges
WARNING:
instructions that follow before you use the
product.
•
There is a risk that the product falls when you
operate it near an edge. Always keep a minimum
of ⅔ of the product on a surface that is sufficiently
stable to hold the product weight.
•
If the product falls, stop the engine before you lift the
product back to a surface that is sufficiently stable.
To lift the product on page 17 .
Refer to
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the engine manual that is supplied by the
engine manufacturer.
•
Do the daily maintenance. Refer to
schedule on page 12 .
1229 - 004 - 12.10.2022
Read the warning
Read the warning
Read the warning
Operation
Read and understand the
Maintenance
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
•
Stop the engine and make sure that all parts of the
product are cool before you do the maintenance.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Disconnect the battery cables from the battery
terminal before you do the maintenance.
•
The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
•
Do not change the product. Modifications that
are not approved by the manufacturer, can cause
serious injury or death.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
Replace damaged, worn or broken parts.
•
Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
•
Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
•
Let an approved service center do servicing on the
product regularly.
To set the handle to operation position
WARNING:
when you change the position of the handle.
There is a risk of injury if the handle falls on
you.
1. Hold the handle.
Hold the handle tightly
9
Advertisement
Chapters
