To set the product in operation position
1. Loosen the handle knobs (A).
2. Lift the handle (B).
3. Tighten the handle knobs (A).
To set the product in transport position
1. Loosen the handle knobs (A).
B
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
1661 - 002 - 13.03.2023
A
B
A
Maintenance
Read and understand the
2. Lower the handle (B).
3. Tighten the handle knobs (A).
To adjust the water flow
•
Turn the water tap (A). Adjust the water flow
between closed (B) and fully open (C) mode.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
B
A
C
13