Operation - Husqvarna BS 75 Operator's Manual

Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust collector
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
4. Do daily maintenance. Refer to
schedule on page 17 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Make sure that only approved persons are in the
work area.
7. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
storage and disposal on page 22 .
8. Connect a dust collector to the product. Refer to
connect a dust collector on page 12 .
9. Adjust the handle to an applicable operation position.
Refer to To adjust the handle height on page 10
To adjust the adjustable handle on page 11 .
and
10. Make sure that the drive wheels are engaged. Refer
To engage and disengage the drive wheels on
to
page 12 .
11. Install a blade. Refer to
page 19 .
WARNING:
with Kevlar. The blades are very sharp.
12. Make sure that the blade is sharp. If it is necessary,
replace or sharpen the blade. Refer to
the blade on page 19 and To sharpen the blade on
page 19 .
10

Operation

Before you operate the
Maintenance
Transportation,
To replace the blade on
Use protective gloves
To replace
13. If you use a self-scoring blade, make sure that the
angles at the ends of the blade (A) are sharp.
A
14. Make sure that the start/stop and function selection
switch is in the "0" position.
To
15. Connect the product to a power supply. Refer to
connect the product to a power supply on page 12 .
To adjust the handle height
1. Loosen the handle adjustment knob.
2. Move the handle to an applicable position.
3. Tighten the handle adjustment knob.
A
To
1804 - 003 - 28.08.2023