Polycom HDX Manual page 2

Polycom HDX Reference Guide
1.
Plug the power cable into the power
outlet in the wall.
2.
Plug the network cable into the network
outlet in the wall. The network cable must
be plugged into the OTN dedicated
network outlet.
3.
Verify that the Power is turned On. The
power bar supplies the whole system. You
can turn off your system here at the end of
your session.
4.
Verify that the monitor is on.
5.
Verify that the codec/camera is on by
checking the switch on the front of the
tower or by pressing the power button at
the top of the remote control.
6.
Pick up the remote control.
Unmute your videoconferencing sound by
pressing the orange "Mute" button located
in the center of the remote control.
March 2023 | pg. 2