5.2 "Stand-By" Mode - 4titude 4s2 Manual

Note: If the drawer is not pushed in fully the locking mechanism may fail
and the motor will stop moving. An error message ("push&hold") will be
displayed and a continuous audible beep will be emitted. To rectify this
and to continue with the sealing process push the drawer in fully until you
can hear a beep. If the problem persists it may be necessary to switch
the unit off and then on again.
As soon as the sample plate makes contact with the heating platen the
display shows the symbol "t" and the countdown of the programmed
sealing time starts.
When the countdown timer reaches zero the unit emits an audible beep
and the drawer is released. The operator can pull out the drawer and
remove the sealed plate.
The unit will emit an audible beep as soon as the heating plate has
reached the programmed temperature again and a new cycle can be
started within a few seconds.
Note: Foil backed film may remain hot for a number of seconds after
sealing. Care should be taken in handling these plates.

5.2 "Stand-by" Mode

If left idle for a prolonged time the sealer will automatically switch into
stand-by mode (factory set at 60 minutes) and the temperature of the
heating plate will be reduced to 60° C.
When entering into stand-by mode the display shows the decrease of the
temperature in real time and the amber LED is switched off.
The temperature of the heating platen will be maintained at 60° C.
The display shows the actual temperature of the heating platen and not
the set sealing temperature.
By pressing any key the unit will automatically begin to warm up the
heating plate to the pre-selected sealing temperature.
Refer to section 4.2 to change the time after which the unit switches into
stand-by mode or to switch off the stand-by function.
4titude Ltd, The North Barn, Surrey Hills Business Park, Damphurst Lane, Wotton, Dorking, Surrey, RH5 6QT, UK
Tel: +44 (0) 1306 884885 Fax: +44 (0) 1306 884886 info@4ti.co.uk www.4ti.co.uk Page | 23