Korg CONCERT C-550 Owner's Manual page 30

Data
7.Attach the Piano.Rest the piano unit on the
rear of the side panel tops, lift it up slightly
and slide it toward the front of the side
panels. Fasten the four piano unit mounting
screws 8 8 8 8 8 to the bottom of the piano.
8
•
Turn the adjuster, so that the bottom makes complete
contact with the floor.
If the adjuster doesn't make contact with the floor, the
Pedals will be unstable and the sound may be affected.
8.Connect the pedal cord and fasten it in
place.
・Insert the connector on the pedal cord
・Fasten the pedal cord with the cord holder.
30
8
in the PEDAL terminal on the rear of the
piano so that the arrow mark is on top.
・The top of the rear panel is open to
improve the acoustics.
Post-assembly Check
o Are there any parts left over?
If there are any parts remaining, check
each of the part positions shown in the
illustration to find where they are miss-
ing.
o Check the mounting screws for any
looseness.
Caution
Cautions when Moving
Please disconnect the piano from the stand
and move them separately. After moving,
reconnect according to these instructions.
Also, be careful of the following points when
moving the piano.
• Wind up the power cord in a small bundle.
If it is left to dangle, the cord could catch on
some other object and be cut, and could
cause short circuits or other damage.
• Be careful that the pedal cord doesn't catch
on a door knob or other object during
moving.
Loose Screws
If a long period of time passes after assembly,
the screws holding the parts of the stand
together may become loose, causing the
stand to wobble. In this case, re-tighten each
screw.
Disassembly
To disassemble the piano and the stand
assembly, follow the assembly procedure in
reverse order. After disassembly, keep the
screws and other parts so that they do not get
lost.