Table of Contents
Advertisement
Moving to the measure you wish to playback
from
Press the [FF] switch and the current measure will
appear in the LED display. After the measure has
appeared, you can press the [FF] switch to advance
in one-measure steps. If you continue holding the
switch, the measure will advance continuously.
If you press this switch during
playback, there will be no sound.
Press the [REW] switch and the current measure will
appear in the LED display. After the measure has
appeared, you can press the [REW] switch to go
backward in one-measure steps. If you continue
holding the switch, the measure will go backward
continuously.
If you press this switch during
playback, there will be no sound.
Listening repeatedly to the playback
You can listen repeatedly to an entire recorded song or
to a portion of it. This is con venient when you wish to
repeat a song, or to practice a dif ficult section.
Repeating an entire song
1.Press the [SONG] switch.
The indicator at the [SONG] switch will light, and the
current song number will appear in the LED display.
2.Press the [+/UP] or [–/DOWN] switch to
select the song number that you wish to
playback repeatedly.
3.Press the [REPEAT] switch.
The indicator at the [REPEAT] switch will light.
4.Press the [START/STOP] switch and the
entire song will be played back repeatedly.
The indicator above the [START/STOP] switch will
blink in time with the tempo.
5.Press the [START/STOP] switch to stop
playback.
The indicator above the [START/STOP] switch will
go off.
2
6.To cancel repeat playback, press the
[REPEAT] switch while playback is stopped.
The indicator at the [REPEAT] switch will go off.
It is not possible to turn off the [REPEAT] switch
during playback.
1
4,5
3,6
Record and playback your performance
Repeating a section A-B
1.Press the [SONG] switch.
The indicator at the [SONG] switch will light, and the
current song number will appear in the LED display.
2.Press the [+/UP] or [–/DOWN] switch to
select the song number that you wish to
playback repeatedly.
3.Press the [START/STOP] switch to begin
playback.
The indicator above the [START/STOP] switch will
blink in time with the tempo.
4.At the location where you wish to begin
repeating, press the [REPEAT] switch.
The indicator at the [REPEAT] switch will blink.
This sets the starting measure of the section to be
repeated.
5.Playback will continue. At the location
where you wish to stop repeating, press the
[REPEAT] switch once again.
The indicator at the [REPEAT] switch will light. This
sets the ending measure of the section to be
repeated. The specified section will now be played
back repeatedly.
2
6.To cancel the specified repeat section,
press the [REPEAT] switch again.
Each time you press the [REPEAT] switch during
playback, the action of the switch will cycle between
"starting measure" → "ending measure" → "cancel
settings" → "starting measure."
7.Press the [START/STOP] switch to stop
playback.
The indicator above the [START/STOP] switch will
go off.
The beginning and end of the repeated area are
set in terms of the measures marked by the
metronome. This means that the actual beginning
of the repetition may be earlier than the point at
which you pressed the switch, and the end may be
later.
While using this A-B repeat function, it is not
possible to use the [REW] or [FF] switches to
move between measures.
1
3,7
4,5,6
17
Advertisement
Table of Contents
