Adjusting The Picture Manually - Panasonic PT-D9610U Operating Instructions Manual

Adjusting the picture manually

Signals which cannot be adjusted automatically should be adjusted manually. The following settings can be
adjusted manually, and the respective adjustment procedures are given below.
1.Input signal resolution data
2.Clock phase
3.Picture position
Adjusting the input signal resolution
Adjustment procedure
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNAL LIST
TEST PATTERN
MENU :
SUB MENU : ENTER
EXIT : MENU
POSITION
SHIFT
SIZE
BLK
CLOCK PHASE
INPUT RESOLUTION
CLAMP POSITION
KEYSTONE
EDGE BLENDING
MENU :
SUB MENU : ENTER
EXIT : MENU
INPUT RESOLUTION
TOTAL DOTS nnnn
DISP DOTS nnnn
TOTAL LINES nnnn
DISP LINES nnnn
DOTS CLOCK nnn. nnMHz
MENU :
ADJUST : ＋−
EXIT : MENU
Numeric values for each item are displayed according to the input signal. If vertical stripes or chipped areas appear
on the screen, increase and decrease the displayed values to adjust the screen to its optimum state.
NOTE
• The input of an all-white picture does not allow the above stripes to appear.
• The picture may become distorted during the automatic adjustment, but this is normal.
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The POSITION screen will be displayed.
Press the UP ( ) and DOWN (
RESOLUTION.
NOTE
• The input resolution can be adjusted when an RGB signal has been input with
the analog RGB module (ET-MD95RGB)
Press the ENTER button. ... The INPUT RESOLUTION screen will be
displayed.
Press the UP ( ) and DOWN (
and then press the control level buttons (+ and -) to adjust.
TOTAL DOTS ----- Total number of horizontal dots
DISP DOTS -------- Actually displayed number of horizontal dots
TOTAL LINES ----- Total number of vertical lines
DISP LINES -------- Actually displayed number of vertical lines
) arrow buttons to select POSITION.
) arrow buttons to select INPUT
) arrow buttons to select the desired item,
49