Panasonic PT-D9610U Operating Instructions Manual page 14

Using the remote control unit with the cable
The remote control unit can be connected to
the projector using the accessory remote
control cable.
This cable should be connected to the
REMOTE IN2 IN terminal at the front of the
projector and to the remote control cable
terminal.
Note:
• The maximum length for the cable used to
connected the remote control unit is 15 m (49 feet).
[Remote control unit]
● ● Using REMOTE IN 1 Terminal
[Projector]
D-SUB9P
REMOTE IN1 Terminal
1
6
2
7
3
8
4
9
5
14
To remote control
cable terminal
Because each pin of the REMOTE IN 1 terminal is controlled by its
open (H) or short (L) as shown in the table below, the addition of an
external control circuit allows the external control for the projector
power supply on and off, the change of the input terminal, and the
switching of the input signal system.
NOTE
Terminals
1 GND
2 POWER
3 RGB
4 INPUT 1
5 INPUT 2
6 INPUT 3
7 LINE / Y / C
8 PIC-MUTE
9 RST / SET
To REMOTE IN2
IN terminal
• To perform external contact control of the projector, turn off
the MAIN POWER switch of the projector, then set pin 9 of
the REMOTE IN 1 terminal to the external contact control
mode (short) using the external control circuit, and then turn
on the MAIN POWER switch of the projector.
• When controlling the projector using the external control
circuit, the external contact control mode (short) at pin 9
disables the buttons on the projector operating panel and the
remote control unit for the projector power supply on and off
and the change of the input terminal functions.
Open(H) Short(L)
OFF
Other
Other INPUT 1
Other INPUT 2
Other INPUT 3
LINE
OFF
Remote control
External contact control
[Projector]
Accessory remote control cable
GND
ON
RGB
Y / C
ON