Lutcontrol; Digitaliocontrol - Omron STC-MBS312POE Product Specifications And User's Manual

11.5

LUTControl

Name
LUTSelector
LUTEnable [LUTSelector]
LUTIndex [LUTSelector]
LUTValue [LUTSelector] [LUTIndex]
LUTValueAll [LUTSelector]
PixelCorrectionAllEnabled
PixelCorrectionIndex
PixelCorrectionEnabled
[PixelCorrectionIndex]
PixelCorrectionX [PixelCorrectionIndex]
PixelCorrectionY [PixelCorrectionIndex]
11.6

DigitalIOControl

Name
LineSelector
LineMode [LineSelector]
LineFormat [LineSelector]
LineSource [LineSelector]
LineInverter [LineSelector]
LineDebounceTime [LineSelector]
LineStatus [LineSelector]
LineStatusAll
UseOutputSelector
UseOutputValue [UseOutputSelector]
STC-MBS312POE / STC-MCS312POE
Product Specifications and User's Guide
Description
Selects which LUT to control.
Activates the selected LUT.
Control the index (offset) of the coefficient to access in the selected
LUT.
Returns the Value at entry LUT Index of the LUT selected by LUT
Selector.
Accesses all the LUT coefficients in a single access without using
individual LUT Index.
Enable pixel correction for all pixels.
Determine index of targeted pixel for pixel correction.
Determine if targeted pixel is enabled for pixel correction.
Determine x-coordinate of targeted pixel for pixel correction.
Determine y-coordinate of targeted pixel for pixel correction.
Description
Selects the physical line (or pin) of the external device connector or the
virtual line of the Transport Layer to configure.
Controls if the physical Line is used to Input or Output a signal.
Controls the current electrical format of the selected physical input or
output Line.
Selects which internal acquisition or I/O source signal to output on the
selected Line.
Controls the inversion of the signal of the selected input or output Line.
Sets the value of the input line debouncer time.
Returns the current status of the selected input or output Line.
Returns the current status of all available Line signals at time of polling
in a single bitfield.
Selects which bit of the User Output register will be set by User Output
Value.
Sets the value of the bit selected by User Output Selector.
No.18S113-03
62/70