Table of Contents
Advertisement
FLASH Button
Pressing [FLASH/CALL WAIT] also allows you to use special features of your host
PBX such as transferring an extension call or accessing optional telephone
services such as call waiting.
• Pressing [FLASH/CALL WAIT] cancels the Temporary Tone Dialing mode or the
mute (p. 51).
Selecting the flash time (use either
The flash time depends on your telephone exchange or host PBX.
You can select the following flash times: "700, 600, 400, 300, 250, 110, 100 or 90
ms (milliseconds)". The factory preset is "700 ms".
• The setting should stay at 700 ms unless pressing [FLASH/CALL WAIT] fails to
pick up the Call Waiting call.
• If the unit is connected via a PBX, PBX functions (transferring a call etc.) might not
work correctly. Consult your PBX supplier for the correct settings.
Base Unit
1
Press [FUNCTION/EDIT].
2
Press [ ] at "Telephone".
3
Scroll to "Initial setting" by pressing
[ ] or [ ], then press [ ].
4
Scroll to "Set tel line" by pressing [ ] or
[ ], then press [ ].
5
Scroll to "Set flash time" by pressing [ ]
or [ ], then press [ ].
6
Select the flash time by pressing [ ] or [ ].
7
Press [ ] (Save), then press [STOP].
Handset
Press [CONF/FUNCTION], and follow steps 2 to 6 above, using the
cordless handset. Press the soft key (
For assistance, please call: 1-800-ADT-ASAP
Base Unit Handset
SAVE
Special Features
or
Base Unit
Telephone
Initial setting
Set tel line
Set flash time
Set flash time
), then press [OFF].
)
Handset
:700ms
53
Advertisement
Table of Contents
