Installation; Connections - Panasonic KX-TG2970B Operating Instructions Manual

Installation

Connections

Base unit
Connect the handset cord to the handset and the base unit, place the handset on
the cradle, and then connect the AC adaptor and the telephone line cord.
Fasten the AC adaptor cord
to prevent it from being
disconnected.
Hook
Power Outlet (AC 120 V, 60 Hz)
Single-Line Telephone Jack (RJ11C)
*Noise Filter
(For DSL users)
• Base unit: USE ONLY WITH Panasonic AC ADAPTOR PQLV10 (Order No.
PQLV10Z).
• Use Only a Panasonic Handset for the KX-TG2970.
• The AC adaptor must remain connected at all times. (It is normal for the adaptor to
feel warm during use.)
• The AC adaptor should be connected to a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to become disconnected.
• If your unit is connected to a PBX which does not support Caller ID, you cannot
access Caller ID services.
• This unit will not function during a power failure, unless it is connected to the ADT
Security System.
• If the unit is connected to a telephone line with DSL service, you may hear noise
during conversations or the unit may not display caller's name and/or phone
number properly. We recommend connecting a noise filter (contact your DSL
service provider) to the telephone line between the base unit and the telephone
line jack.
10
AC Adaptor
Telephone
Line Cord
Raise the antennas.
Handset
Handset Cord