When the indication "voltage present"
does not appear, it is highly recommended
installing earthing equipment before work.
2. INTRODUCTION
2.1 Inspection
Examine the shipping carton for any
sign of damage. Inspect the unit and any
accessories for damage. If there is any
damage then consult your distributor
immediately.
2.2 Description
The VT12 is a voltage tester used for
proving circuits are dead i.e. not hazardous
live. It is constructed in accordance with the
latest safety standards.
The voltage tester has the following
features:
AC and DC Voltage testing up to 690V
u
Continuity test with optical and
u
acoustical indication up to 500kΩ
Single pole phase test
u
Automatic AC/DC detection
u
Bright LED indication
u
Indication of voltage above the ELV level
u
when batteries flat
Ergonomic and robust housing
u
Probe-tip protection
u
Complies with BS EN 61243-3:2014
u
Complies with GS38 when probe tip
u
covers are fitted
Measurement Category CAT IV 300V,
u
CAT III 690V
2.3 Accessories
Probe tip covers (fitted)
u
2 x 1.5V AAA alkaline batteries
u
Instructions
u
2.4 Battery Installation
Refer to Section 4.1 (Battery Replacement)
for battery installation instructions.
4