Advertisement
- NAT Gas / LPG / Butane Only.
NOTE: Gas
regulator
convertible between Natural Gas
and LP Gas, but it's outlet
pressure is fixed ex-factory and
is NOT to be adjusted.
- Town Gas Only.
1.
Remove slotted cap from regulator.
2.
Turn 'On' gas supply and appliance.
3.
Adjust pressure adjusting screw to achieve correct burner
operating pressure.
NOTE: Measure burner operating pressure at gas valve outlet
test point with burner operating at 'High Flame'
setting.
4.
Verify operating pressure remains correct (Re-adjust
regulator if required).
5.
Screw cap nut back onto regulator.
On completion of the gas conversion, replace the gas type labels located at:-
- Rear of the appliance, above the gas connection point.
- Beside the rating plate.
Before leaving installation;
1.
Check all gas connections for leaking using soapy water or other gas detecting equipment.
2.
Carry out a 'Commissioning' check of the appliance as shown in the Installation Section of this
manual.
3.
Ensure that any adjustments done to components that have adjustments / settings that are paint
sealed, these are to be re-sealed.
NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut 'Off' the
gas and power supply and contact supplier of this appliance.
supplied
is
D
O NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES
18
NOTE, Pin rotated
for Natural Gas.
NOTE, Pin rotated
for LPG.
Cap Nut
Pressure Adjusting
Screw
.
Advertisement
