Remote Control And Monitoring Via Diacom - Delta DX-3021L9 Series User Manual

Notice

If the device's RS-232 / RS-485 is not operating in Transparent mode, the
corresponding button is grayed out.

DIACom will prompt an error message if the FW version of DX is under V1.3.3.

When RS-232 or RS-485 works in Transparent mode, click on the [Create Serial
Port] button on RS-485 to create a virtual serial port.
4.2.3

Remote Control and Monitoring via DIACom

4.2.3.1 Via a LAN Port
If your router is connected to remote devices via a LAN port, you can use the
configuring/monitoring software on your local computer to configure and monitor after opening a
virtual tunnel. Some program would require the IP addresses of your remote device. Simply input
the required information in the configuring/monitoring software and then you can configure and
monitor the connected device remotely.
4.2.3.2 Via a RS232/RS485 Port
After opening a virtual tunnel, you will need to follow the setups below before using WPLSoft or
other configuring/monitoring software on your local computer to configure and monitor the
connected device remotely.
Cha p ter 4 In tr od ucti on to D IACo m
4_
4 - 1 1