Table of Contents
Advertisement
SDD2ELEMIC INTEGRATED
DOWNDRAFT RANGEHOOD
INSTALLATION GUIDE
INSTALLING THE RANGEHOOD
NOTE
Certain installations will require ducting
provisions to be completed prior to this stage.
See Pages 16-19 for applicable motor
installations
•
Before carrying out the appliance installation,
please check that all components are not
damaged, in such a case contact your retailer
and do not carry out any installation operation.
Before the installation of the downdraft, please
remove the safety piece you can see in the
picture (Fig. 1a). Leave all other protective
tape in place at this point. Furthermore, please
read carefully all of the following installation
instructions.
•
Use Sirius ducting with a maximum length of 7
metres to the motor.
•
Limit the number of elbows in the ducting, since
each elbow reduces the air capacity of 1 linear
meter. (Ex: if you use no. 2 x 90° elbows, the
length of piping should not exceed 5 meters).
•
Avoid abrupt direction changes. (Optimum angle
45° when required)
•
Use a 200mm ducting - constant diameter pipe
for the whole length.
Use ducting approved by standards enforced - see
www.siriusbrand.com.au for approved ducting
The manufacturer shall not be deemed responsible
for air capacity or noise problems caused by failure to
comply with the above instructions and no warranty
on the product shall be provided.
The cutout MUST be done by a professional. It is vital that the cutout is perfectly made so
as not to have fitment issues with the product. The cutout section can be used (thickness
dependent, Min. 10mm - 32mm Max.) as the top of the downdraft so it matches the
benchtop perfectly.
Should these instructions be ignored, the manufacturer or agent will not be held
responsible for any damage caused to either downdraft, benchtops or cabinetry.
STEP 1:
Refer to cutout dimensions required per unit as they
vary for each unit.
1. Before making the cutout, check that there are no
structural or other parts inside the cabinet where
the appliance is to be placed which could hinder
a proper installation. Check that the dimensions
of the downdraft and the cooktop are compatible
with the cabinet so that the installation can be
carried out properly.
2. Make a rectangular cutout, with a radius of 10 on
each corner, at the rear of the cooktop location:
•
837mm x 100mm for the 880mm model
•
1137mm x 100mm for the 1180mm model.
(Fig. 2)
3. Lower the downdraft section into the cut out to
ensure clearance is sufficient for installation.
(Fig. 1b)
Front 200mm duct adapter will need to be
removed to allow the unit to clear
Technical specifications and product sizes
can be varied by the manufacturer without
notice. Cut out dimensions are indicitive only
and physical measurement should be taken as
a precautionary measure to ensure no issues
NOTE
8
NOTE
WARNING
arise with fitment.
Advertisement
Table of Contents
