Using The Rangehood / Maintenance; Replacing The Led Light - Sirius Satellite Radio SM923L520 Installation Instructions Manual

USING THE RANGEHOOD
SM923 and SM924 (fig. 11)
A: Motor switch on speed 1/off - (low/simmer)
B: Motor switch on speed 2 - (general cooking)
C: Motor switch on speed 3 - (high power)
D: Motor switch on speed 4 - (booster)
E: Light on/off switch
MAINTENANCE
• Accurate maintenance guarantees good
functioning and long-lasting performance.
• Particular care is due to the grease filter panel. It
can be removed by pushing its handle toward the
back side of the rangehood and pulling the filter
downwards so to unfasten it from its slot (Fig.3).
To insert the filter just perform the opposite
operation.
• The grease filter needs cleaning by regular
handwashing or in dishwashers every two
months or 30 continuous hours, depending on its
use. Button lights will flash when filter needs to
be cleaned. To reset, press and hold the the 01
button for 2 seconds when the motor is off.
Filters may require cleaning sooner if
frequent heavy frying is done.
• To clean the appliance itself, water and detergent
are recommended, while abrasive products
should be avoided. For steel appliances
specialized detergents are recommended (please
follow the instructions indicated on the product
itself to obtain the desired results).
NOTE
To remove the rangehood from the cabinet,
remove the fixing screws (fig. 6) using a
screwdriver, and remove the grease filters
• Push down on the small handle of the springs,
which are inside the rangehood, with the
necessary strength to unhook the hood from the
cabinet.
WARNING
If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard.
(Fig.11)
(fig.3).
REPLACING THE LED LIGHT ON THE
SM924
1. Before replacing the LED light, switch off the
rangehood, then - by using appropriate tools -
remove the LED light from its slot (fig.12).
2. Take out the LED light from its connector and
replace.
• To find the correct LED light, please contact Sirius
directly on our toll-free number: 1300 762 216.
• NB: light is easier to remove from centre of
LED globe. Use a small, flathead screwdriver
(pictured), pallette knife or blunt butter knife.
REMOVING THE LED LIGHT FROM
THE SM923L
• Using a pallet knife or small flathead screwdriver,
starting from the centre of the light, gently slide
in and twist along the length of the light cover
until the light can be pulled out.
• Disconnect the two pin plug and plug in the new
led bar.
• Push the light bar back into place until the clips
snap into place.
9
(Fig.12)