Table of Contents
Advertisement
Projector body
Front
1 2
3 4
5
6
Rear
8
8
Bottom
Projection direction
1
Remote control signal receiver (front)
2
Power indicator <开（绿）/待机（红）>
Indicates the status of the power.
Attention
f Do not block the intake/exhaust vents of the projector.
Note
f For the connection using the NFC function, use the application software "Smart Projector Control" which performs the setting and
adjustment of the projector.
For details of the "Smart Projector Control", visit the website (https://panasonic.net/cns/projector/).
Chapter 1 Preparation — About your projector
Side
5
7
8
6
14
6
9
10
3
Light source indicator <光源>
Indicates the status of the light source.
4
Temperature indicator <温度>
Indicates the internal temperature status.
5
Adjustable feet
Adjusts the projection angle.
6
Intake vent
7
Remote control signal receiver (rear)
8
Exhaust vent
9
Control panel (x page 28)
10 Connecting terminals (x page 29)
11 NFC touch point
This is the touch point when using the near field communication
(NFC, Near Field Communication) function. A device such as a
smartphone equipped with the NFC function can be connected
to the projector by holding it near the touch point.
12 <电源接口> terminal
Connect the supplied power cord.
13 <主电源> switch
Turns on/off the main power.
14 Security bar
A wire, etc., can be attached to prevent theft.
6
11
12 13
ENGLISH - 27
Advertisement
Table of Contents
