Table of Contents
Advertisement
3)
Press as to select [MODE].
4)
Press qw to switch the item.
[INTERNAL]
[FULL]
5)
Press as to select [INTERLOCKED].
6)
Press qw to switch the item.
[OFF]
[ON]
7)
Press as to select [VERTICAL] or [HORIZONTAL].
f If [ON] is selected, select [BOTH].
8)
Press qw to adjust.
Note
f When [ASPECT] is not set to [DEFAULT], [MODE] is not displayed.
f Zoom ratio less than 100 cannot be set when the video signal fulfilling one of the following conditions is being input.
g Video signal with resolution exceeding 1 920 x 1 200 dots
g Video signal with dot clock frequency exceeding 160 MHz
f [ZOOM] cannot be adjusted when the image of 1920 x 1080/240 is projected.
The video signal of 1920 x 1080/240 can be input when the optional High Frame Rate Upgrade Kit (Model No.: ET-SUK10) is applied.
[GEOMETRY]
You can correct various types of distortion in a projected image.
Unique image processing technology enables projection of a square image on a special screen shape.
The projected image can be made to look more natural by making topical correction as necessary.
1)
Press as to select [GEOMETRY].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[KEYSTONE]
[CORNER/PINCUSHION]
[CURVED CORRECTION]
[PC-1]
[PC-2]
[PC-3]
*1 "Geometric & Setup Management Software" can be downloaded from the website (https://panasonic.net/cns/projector/pass/). It is necessary
to register and login to PASS to download.
Note
f The menu, logo, or waveform monitor display may run off the screen when [GEOMETRY] is set.
f If [EDGE BLENDING] (x page 119) adjustment and [GEOMETRY] are used together, correct edge blending adjustment may not be
possible in certain environments.
f The [GEOMETRY] setting is disabled when the following condition applies, and the geometric adjustment function cannot be used.
g When the [ADVANCED MENU] menu → [QUAD PIXEL DRIVE] is set to [OFF]
f The image may disappear for a moment or may be disrupted while performing adjustment, but it is not a malfunction.
f When the video signal of 1920 x 1080/240 is input, the image is displayed in the 90 % region at the top of the screen (16:9 region). Rest of
the 10 % at the bottom of the screen will be black.
The video signal of 1920 x 1080/240 can be input when the optional High Frame Rate Upgrade Kit (Model No.: ET-SUK10) is applied.
Setting [KEYSTONE] or [CURVED CORRECTION]
1)
Press as to select [GEOMETRY].
2)
Press qw to select [KEYSTONE] or [CURVED CORRECTION].
112 - ENGLISH
Chapter 4 Settings — [POSITION] menu
Enlarges the size within the aspect range set with [SCREEN FORMAT].
Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].
Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.
Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the
same magnification.
Does not perform geometric adjustment.
Adjusts any trapezoidal distortion in the projected image.
Adjusts any distortion in the four corners of the projected image.
Adjusts any curved distortion in the projected image.
Select this item when performing correction using a computer and "Geometric & Setup Management
Software"
. Up to three correction data can be saved.
*1
Advertisement
Table of Contents
