Table of Contents
Advertisement
◆ The maximum current of 10A socket is 10A, over-current will destroy the meter, and will damage
the operator.
◆ In" AC " mode, only can input "AC ", if not, will damage the meter.
Resistance Measuring
WARNING!
When measuring in-circuit resistance, be sure the circuit under test has all power removed and that all
capacitors have discharged fully.
a. Connect the black test lead to the "COM " jack and the red test lead to the "V/
Ω
b. to select Ω, enter the
t
he tester default Auto range status, Press the key manually select range ,Press "NEAR" to restore
"Auto range"
Manual range:(Connect the red lead to black leads, will display the measure range)
Continuity Testing
a. Connect the black test lead to the "COM" jack and the red test lead to the "V/
b.to select
, enter the continuity test, Connect test leads across two point of the circuit under testing.
c. If continuity exists (i.e., resistance less than about 50Ω), built-in buzzer will sound.
Diode Testing
measurement
000.0Ω
→ 660Ω
0.000 KΩ → 6.600KΩ range
00.00 KΩ → 66.00KΩ range
000.0 KΩ → 660.0KΩ range
0.000 MΩ → 6.600MΩ range
00.00 MΩ → 66.00MΩ rang
Page.80.
range
Ω
" jack.
Ω
"
jack.
Advertisement
Table of Contents
