Table of Contents
Advertisement
Ethernet tester.
Click on the Trace Route icon
to enter trace route
Input tracking IP address or domain name in the Remote Host IP. Set maximum hop count, normally
default is 30.
Click "start" to trace the goal address
（7）Link monitor
Click the
icon to open the Link Monitor app. This app is used to see if an IP address is occupied
by other network devices. This will avoid new address conflicts
Click "Add" and enter the desired IP address. To test different network segments, click the "Settings"
icon on the main menu and go to IP Settings and make the desired changes. Once the desired IP
addresses are added to the Link Monitor list, click "Start". If the IP address status shows a check mark
Page.65.
Advertisement
Table of Contents
