Quick Reference Table - Supermicro SuperServer SYS-E302-12D-4C User Manual

Quick Reference Table

Jumper Description
J1 SIM Card Detection
JBM1 Disable IPMI Share LAN
JBT1 CMOS Clear
JNS1 SlimSAS Interface Selection
JPF1 Power Force On
JPG1 VGA Enable/Disable
JPL1, JPL2, JPL3 LAN1, LAN2, LAN3/4 Enable
JPME2 ME Manufacturing Mode
JPT1 Onboard TPM Enable/Disable
JWD1 Watchdog Timer
LED Description
LED1 Power LED
LED3 Overheat (OH)/Power Fail/Fan Fail LED
LEDM1 IPMI Heartbeat LED
Connector
BT1
COM1
FAN1 - FAN4, FANA, FANB
IPMI LAN
I-SATA1 and I-SATA3
I-SGPIO1
JD1
JF1
JGP1
JIPMB1
JL1
JLANLED1
JLANLED2
JLANLED3
JMD1
JMD2
Description
Onboard Battery
COM Header
CPU/System Fan Headers (FAN1: CPU Fan)
Dedicated IPMI LAN Port
Intel PCH SATA 3.0 Ports (I-SATA1: SATA DOM Power)
Serial Link General Purpose I/O Header
Power LED/Speaker (Pins 1-3: Power LED, Pins 4-7: Speaker)
Front Control Panel Header
General Purpose I/O Header
4-pin IPMI External I C Header
2
Chassis Intrusion Header
LAN1 Activity LED Header
LAN2 Activity LED Header
LAN3/4 Activity LED Header
M.2 PCIe 3.0 x4 or SATA 3.0 Slot (M-Key 2280)
M.2 PCIe 3.0 x2 or SATA 3.0 or USB 3.0 Slot (B-Key 2280/3042/3052)
13
Chapter 1: Introduction
Default Setting
Pins 1-2: High Active (Default)
Pins 2-3: Low Active
Pins 1-2: IPMI Share Lan Disabled
Open: IPMI Share Lan Enabled (Default)
Open (Normal)
Pins 1-2: 4X SATA
Pins 2-3: PCIe x4 (Default)
Pins 1-2: ATX Mode (Default)
Pins 2-3: Force PS-ON mode
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
Status
Solid Green: Power On
Solid Red: Overheat
Blinking Red: Power Fail or Fan Fail
Blinking Green: IPMI Normal