Raider GT-GT23 User Manual page 15

4 . Practical tips:
4.1. Follow local regulations for the time of day during which you can use machines
outdoors. In some countries prohibit mowing morning before 08.00 hours, in the afternoon
between 2:00 p.m. to 16:00 hours and after 22:00 at night, to protect citizens from unwanted
noise.
4.2 . Often lawns are composed of grasses of different varieties . With frequent mowing you
will boost the growth of those species that form dense sod and strong roots. If you mow your
lawn frequently will strengthen and improve the development of high- growing grasses and
weeds . The normal height of the grass is about 4-5 cm. Better to plan the frequency of mowing
a lawn that can reduce up to 1 /3 of the total height of the grass. If you do not irrigate your lawn,
mow grass lower than 4 cm, since a potential drought it will degenerate .
4.3 . When working in very difficult conditions not to overload the motor. When reloading
the rotational speed of the motor drops and noise is changed . In this case, stop, release the
lever to include ( 1 ) and set higher mowing height . Otherwise, performance will be reduced
and the machine may be damaged .
4.4 . When cutting close to edges careful not to pinch trim foreign objects .
4.5 . Cutting performance depend on the density, moisture content, length of the grass and
the cutting height . Cutting performance decreases with frequent switching on and off of the
trimmer during mowing . To optimize the performance of the cutting recommended frequent
cutting, increasing the height of the cutting operation and at a moderate speed .
5 . Servicing, maintenance and storage.
ATTENTION! Always disconnect the plug from the wall outlet before making activities
related to maintenance or cleaning !
Once the machine is turned off, the cord continues to rotate for some time by inertia ! Before
you start working on trimming wait rotation of the motor and the cord to stop completely!
Never try to stop the rotation of the cord !
When you need to perform tasks near cord always operate with gloves !
Perform maintenance procedures regularly to ensure your long-term and reliable use of the
trimmer . Periodically check for visible defects such as loose or damaged knife and loosened
screw connections . Make sure the covers and guards are undamaged and are installed
properly.
5.1. Cleaning.
The easiest way to clean the trimmer immediately after mowing . After working on the
machine clean thoroughly with a soft brush and cloth. Do not use water and / or solvents and
detergents. Remove all particles of grass, especially from vents . Place the machine on its
side and clean the area of the cord . Always wear protective gloves ! Remove firmly adhering
particles of wood or plastic block .
5.2 . Always clean the main trimmer when leaving it for longer storage. Especially in winter.
6 . Faults and correct them.
The table below shows symptoms of failure and how you can help if you trimmer stop
working properly. If you do not find and fix the problem by following the instructions in the
table, contact your authorized dealer Ryder . Attention : Before you start troubleshooting, stop
trimmer and disconnect it from the mains.
15