Table of Contents
Advertisement
Command port set up page
Set the port number to be used with command control.
Click [Detailed set up] → [Command port set up].
Input the port number to be used with command
control.
Setting update button.
SNMP set up
Sets the various items for SNMP.
SNMP (Simple Network Management Protocol) is a
protocol to manage devices connected to the network.
If the SNMP manager is used for connection, the
information of the target device can be obtained, and its
settings can be changed.
Click [Detailed set up] → [SNMP set up].
[SNMP]:
Select the SNMP version to use.
[SNMP v1/v2c] [COMMUNITY]
[COMMUNITY NAME]:
Enter the community name of SNMP v1/v2c.
[PERMISSION]:
Select whether to obtain only information via SNMP
v1/v2c or to both obtain information and make the
setting.
[TRAP SETTINGS]
[TRAP]:
Select the SNMP version to use when sending
TRAP.
[COMMUNITY]:
Select COMMUNITY to use when sending TRAP.
92
English
[TRAP ADDRESS]
[ADDRESS]:
Set the IP address of the SNMP manager that gives
notice of TRAP.
[PORT]:
Set the TRAP reception port number of the SNMP
manager that gives notice of TRAP.
[TRAP OPTIONS]
[POWER]:
TRAP is sent if the unit enters the standby mode by
"Power management", [No signal power off] or [No
activity power off].
[NO SIGNAL]:
TRAP is sent if no-signal continues for 5 minutes.
[TEMPERTURE]:
TRAP is sent if the temperature error occurs.
[AUTHENTICATION]:
TRAP is sent if the SNMP authentication fails.
Note
●
The maximum number of characters that can be
used for a community name is 32 with one-byte
alphanumeric characters.
●
The SNMP manager must be operating in the system
configuration used.
●
For MIB (Management Information Base) of this unit,
see the web site below.
https://panasonic.net/cns/prodisplays
●
For the settings of the SNMP manager, consult with
the network administrator.
Advertisement
Table of Contents
