Table of Contents
Advertisement
[HDMI1 power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at HDMI1 input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at HDMI1 input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the
video output devices.
[HDMI2 power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at HDMI2 input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at HDMI2 input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the
video output devices.
[DIGITAL LINK power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at DIGITAL LINK input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at DIGITAL LINK input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the
video output devices.
52
English
[DVI-D power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at DVI-D input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at DVI-D input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.
[PC power management] (DPMS function)
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (HD/VD sync signals) are
detected for 60 seconds or so at PC input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (HD/VD sync signals) are
subsequently detected at PC input:
Power is turned on; the power indicator lights up
green.
Note
●
This function is effective when [Sync] in [Signal] is set
to [Auto] or [HV sync] and [Component/RGB-in select]
are set to [RGB]. (see page 48)
●
This function may not operate depending on the video
output devices.
[Power save]
This function adjusts the brightness of the backlight to
reduce power consumption.
[Off]:
The power save function does not operate.
[On]:
Backlight brightness is reduced.
Note
●
If this function is set to [On] when [Setup] - [LightID]
is set to [External control] or [Internal ID], [Picture] -
[Backlight] is fixed to [Low].
Advertisement
Table of Contents
