Panasonic SF2H Series Operating Instructions Manual page 27

Pin assignments and signal names for USB Terminal
1
Pin No.
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5V/1A can be supplied to an external
device when the picture is displayed.
●
If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off/on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
● When connecting the USB memory device, confirm
the orientation of the plug to prevent damage to the
terminal.
●
When removing the USB memory device, note the
following.
When the access indicator of the connected USB
•
memory device is blinking, it shows the display is
loading the data. Do not remove the USB memory
device while blinking.
Depending on the USB memory device, the access
•
indicator may remain blinking even when it is not
being accessed, or the device is not equipped
with an access indicator function, etc. In this case,
remove the USB memory device after confirming
the following or
Switch the input to an input other than [USB]
and [MEMORY VIEWER], and confirm that the
functions that access USB memory device are
finished. The functions are, read user image
function (see page 55), playlist edit function (see
page 103), data cloning function (see page 114),
etc.
Turn the unit off.
2 3 4
Signal name
.
Do not frequently repeat connecting/disconnecting
•
the USB memory device. Wait at least 5 seconds
after connection, and then remove the USB
memory device. Before reconnection, wait at least
5 seconds. A certain length of time is required
so that the display can recognise that the USB
memory device is switched for connection or
disconnection.
If the power of this unit is turned off or the USB
•
memory device is removed accidentally while
accessing data, the data may not be accessed
next time the USB memory device is used.
In such a case, turn the power of the main unit off
and on.
27
English