Panasonic SF2H Series Operating Instructions Manual page 70

● [Changing delay] is the function to prevent the
accidental input switch during a short period, such as
when the signal is interrupted due to the frequency
change for the input signal while [Input detection] is
operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
●
[Input detection] may not operate correctly depending
on the image playback device.
Failover/Failback
Automatically switches to the backup input if an
interruption of video occurs.
Note
●
MEMORY VIEWER input is excluded from this
function.
1
Select the item with
Select the set point with
[Input change mode]
[Off]:
Disables the Backup Input function.
Failover/Failback
Input change mode
[Quick]:
Promptly switches to the backup input if an
interruption of video occurs.
The backup video signal needs to be in the same
format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the (main) input used
for viewing will be inherited.
Failover/Failback
Input change mode
Primary backup input
Secondary backup input
Auto switch back mode
Changing mode
Backup input change
Main input
Current input
[Normal]:
Switches to the backup input if an interruption of
video occurs.
The backup video signal does not need to be in the
same format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the backup input will
be used.
70
English
.
.
Off
Quick
HDMI1
DVI-D
Disable
High speed
Active
HDMI2
Main input
■
[Input change mode]: [Quick]
Promptly switches to the backup input if an
interruption of video occurs, and enables switching
between digital (HDMI1 / HDMI2 / DIGITAL LINK /
DVI-D) inputs.
Note
●
The backup video signal needs to be in the same
format as the (main) input in use for viewing.
●
Upon switching to the backup input, the video and
audio adjustment values for the (main) input used for
viewing will be inherited.
●
This function will start operating once a video signal is
detected by both the input in use for viewing and the
backup input and the [Backup input change] item is
displayed as [Active].
● This function may not operate correctly depending on
the image playback device.
[Primary backup input]
Sets the first priority backup input.
(None) / [HDMI1] / [HDMI2] / [DIGITAL LINK] /
[DVI-D]
The input name that is of the same type as the one in
use for viewing will be greyed out.
[Secondary backup input]
Sets the second priority backup input.
(None) / [HDMI1] / [HDMI2] / [DIGITAL LINK] /
[DVI-D]
The input name that is of the same type as the one in
use for viewing will be greyed out.
[Auto switch back mode]
Sets whether or not to automatically return to the
former (main) input when the former input video
initially viewed is restored while viewing the video
of the backup input enabled by the operation of the
Backup Input function.
[Disable]:
Unreturned
[Enable]:
Returned
[Changing mode]
Select speed of input switching.
[High speed]:
If switching between the same signal formats, it is
possible to switch within 1 second.
If switching between the different signal formats,
picture noise is caused.
[Normal speed]:
If switching between the same signal formats, it is
possible to switch within 2 seconds.
If switching between the different signal formats, it
takes 3 to 4 seconds to switch but picture noise is
not caused.