Panasonic SF2H Series Operating Instructions Manual page 75

Full hd lcd display for business use
Table of Contents

Advertisement

Controller ID function
Enables/Disables the ID remote control function.
To operate this function, please purchase ID remote
controller sold separately. (see page 121)
[Off]:
Disables the ID remote control function. (Can be
operated as normal remote control.)
[On]:
Enables the ID remote control function.
Effective on switching to [On].
Note
To use the ID remote control function, setting ID
numbers both for the remote control and for the
display is required.
For ID number setting for the remote control and
display, see page 121 and [Display ID] respectively.
About how to reset the settings to defaults, refer to
"Initialization" (see page 77)
Serial ID function
Set to control external control with the PC connected to
SERIAL terminal according to the Display's ID number
(Panel ID).
[Off]:
Disables external control by the ID.
[On]:
Enables the external control by the ID.
Serial response(Normal)
Sets whether to send the response command to normal
commands without ID.
[Off]:
Does not respond. (Including the inquiry command)
[On]:
Responds.
Serial response(ID all)
Sets whether to respond to the command or not, when
serial command of ID No "0" is received.
[Off]:
Does not respond.
[On]:
Responds.
Serial daisy chain position
Set the first and last terminals in the chain when the
SERIAL IN/OUT terminal of this unit is connected using
a daisy chain scheme.
[---]:
When controlling this unit alone with serial control,
or connecting at a position other than the first and
last terminals in a daisy chain
[Top]:
When connecting at the first terminal in a daisy
chain
[End]:
When connecting at the last terminal in a daisy
chain
LAN control protocol
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
When operating the "Multi Monitoring & Control
Software", select [Protocol 2].
75
English

Advertisement

Table of Contents
loading

Table of Contents