Supermicro X13SEI-TF User Manual page 88

Super X13SEI-TF/-F User's Manual
Spin Up Device
Select Enable for Staggered Spin Up support. This feature allows the SATA devices you
specified to spin up one at a time at boot up in an effort to prevent all hard drive disks
from spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port you specified should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive
and Solid State Drive.
Trusted Computing

The motherboard supports TPM 2.0. The following Trusted Platform Module (TPM) information
is displayed if a TPM 2.0 module is detected:
•
Firmware Version
•
Vendor
Security Device Support
Select Enable to enable BIOS support for onboard security devices, which are not displayed
in the OS. If this feature is set to Enable, TCG EFI protocol and INT1A interface will not be
available. The options are Disable and Enable.
*When "Security Device Support" is set to Enable, the following information will display:
•
Active PCR banks
•
Available PCR banks
SHA256 PCR Bank (Available when "Security Device Support" is set to Enable)
Select Enabled to enable SHA256 PCR Bank support to enhance system integrity and data
security. The options are Disabled and Enabled.
Pending Operation (Available when "Security Device Support" is set to Enable)
Use this feature to schedule a TPM-related operation to be performed by a security (TPM)
device at the next system boot to enhance system data integrity. Your system will reboot to
carry out a pending TPM operation. The options are None and TPM Clear.
Note: Your system will reboot to carry out a pending TPM operation.
88