Replacing The Motor Convection - Samsung NX58H5600SS/AA Service Manual

3. Disassembly and Reassembly
3-20 Replacing the Motor Convection (Ver.00)
CAUTION
When you work on the gas range, be careful when handling sheet metal parts. Sharp edges may be
present, and you can cut yourself if you are not careful.
Parts
Motor
Convection
(Parts Code:
DG31-00014D)
CONNECTOR
FAN
Unbend the bracket
1. Turn off the electrical supply going
to the range.
2. Shut off the gas shut-off valve in
the gas supply line to the range.
3. Remove the cover-back main wire
and the cover-convection.
4. Note, mark, and disconnect wires
or connector going to the motor
convection
5. Open the oven door and remove
the racks from inside the oven.
6. Remove 2 screws and the interior
cover casing from the back wall of
the oven cavity.
FAN NUT
7. Remove the fan nut, fan blade
from the motor convection shaft.
(The convection nut has clockwise
threads to remove the nut.)
8. Unbend the bracket of the back
main to the rear of the range.
9. Pull the motor convection straight
out while rotating the motor
convection counter-clockwise.
10. When the service is complete,
reverse the order to install the
motor convection.
Note. Do not fasten the fan nuts too
33
strong.