Samsung NX58H5600SS/AA Service Manual page 46

4. Troubleshooting
4-1 Failure Display Codes
Failure code
E-0E
E-0E
*Disconnect power.
*Get rid of harness connected with Lock motor.
* Check the door lock switches(com-NO)
* Measure resistance of Lock motor
Ok
*Check whether voltage(AC 120V) is offered
to lock motor with letting lock work or not.
Ok
*Check whether harness connected
normally into CN501 on PCB.
*Measure resistance CN501 on PCB.
*COM : Yellow Wire *NO : White Wire
CAUSE
Door locking error
(Door lock in wrong position
after 1 minute.)
1) Disconnect electrical power to the range.
Remove the rear cover panel. Make sure the
wiring harness is properly connected to the
motorized door lock assembly.
2) Check motorized door lock assembly for
proper operating resistance.
3) With operating door lockout, measure the
voltage of connector on harness which is
linked with door lock motor.
(Normal :Voltage : AC 120V)
3) Check the door locking switch to make sure
it is working properly.
CN501
No
* Replace faulty door lock switch or Lock motor.
END
No
Door lock
Switch
No
COM
* Repair damaged harness or Replace.
* Replace PCB.
No
* Solder again if pattern is damaged or
parts is Wrong Contacted.
END
44
SOLUTION
NO