Compaq GS320 Installation And User Manual page 237

Location of Model Type Information
The instructions below differ according to model. You can determine the model
of the SMC system by looking at the label on the top or side of the minitower or
desktop box.
Models DPENM and DPEND
1. Shut down the SMC system and disconnect the power cord.
2. Remove the cover from the SMC box.
3. Locate the switchpack on the motherboard. Figure 11–13 and the label
inside the SMC cover show the location of the switchpack.
4. Set switch 6 to on (Figure 11–13).
5. Replace the cover and connect the power cord.
Models ENCM and ENL
1. Start or restart the SMC system.
2. During power up, at the initial screen with the large Compaq logo, press the
F10 key for setup. A list of languages, with English selected, displays. Press
Enter
3. The Setup Utility screen displays. Use the right-arrow key to select the
Advanced menu. The Power-On Options item is selected. Press Enter.
4. The Power-On Options box displays. Check the setting for the entry After
Power Loss. If it is Off, press the down-arrow to move the pointer to this
setting. Press the right-arrow key to change the setting to On. Press F10 to
accept this change.
5. The Setup Utility screen displays. Use the left-arrow key to select the File
menu. Press the down-arrow key to select Save Changes and Exit. Press
Enter. The power-up procedure continues.
Troubleshooting 11-23