infaco ELECTROCOUP F3015 Instructions Manual page 65

SUFFICIENT CONDUCTIVITY : THE PRUNING SHEARS DO NOT START
During calibration, the bar graph indicated a green ON/OFF Status LED, refl ecting
excellent to low conductivity levels. However, the pruning shears do not start.
Repeat the calibration steps making sure to release the trigger before breaking
contact between the bottom of the hook and the hand and/or glove.
Conductivity
level
Bar graph
ON/OFF LED
Observations:
For all troubleshooting, refer to the chapter entitled, LED Indications in the
F3015 manual.
USE OF THE DEVICE IS PROHIBITED IF THERE IS A SAFETY SYSTEM MALFUNCTION.
Excellent Good
16
Acceptable Low