infaco ELECTROCOUP F3015 Instructions Manual page 63

Press the trigger twice to start the pruning shears: cutting work can then
begin.
If the calibration step is not carried out correctly, or if the conductivity level is
insuffi cient, the pruning shears will not start: the ON/OFF status LED will turn red.
In these cases repeat the calibration steps carefully. If the fault persists, refer to the
Troubleshooting section in the manual.
After starting, always hold the free hand a distance of at least 7.9" (20 cm)
from the blade of the tool.
TABLE OF CONDUCTIVITY LEVELS (WITH BARE HAND OR GLOVE)
Conductivity
Excellent
level
bar graph
ON/OFF LED
Good Acceptable
14
Low Insuffi cient