infaco ELECTROCOUP F3015 Instructions Manual page 62

2
Place the bottom of the hook in direct contact with the tips of the fi ngers
on the hand opposite the one holding the shear, wearing an INFACO conductive
glove or not, depending on your work confi guration.
Move over the entire surface of the hand and/or glove in this way (palm of the
hand and the fi ve fi ngers, inside and outside) while keeping the trigger pressed to
check the different conductivity levels of your hand, whether gloved or not, using
the bar graph.
3
Once the operation is fi nished,
graph indicates the lowest level of conductivity (see Table of Conductivity
Levels) and release the trigger to calibrate the unit.
fl ashes green: calibration is fi nished.
position the hook on the area at which the bar
13
Trigger activated
Trigger released
The ON/OFF status LED