Network Joining; End Device Binding - netvox Z810B User Manual

4.2 Network Joining

In order to enable Z810B to connect with other devices under the Zigbee network, Z810B needs to be
added to the Zigbee network, and the network addition operation is as follows:
(a) Turn on the "allow network addition function" of the coordinator or router device in the same channel
as Z810B in the network.
(b) If Z810B is used as a router in the network, it will actively search for the network after power-on and
will keep flashing before it joins the network, and the value area will display power information.
(c) If the network is added successfully, the light will remain on and the LCD value area will display the
power information. As shown below:

4.3 End Device Binding

For the objects that Z810B can be bound to, the client side has on/off Cluster control device binding, such
as Z503/Z501 of netvox, the binding operation is as follows:
(a) Press and hold the binding key for 3 seconds, the
area will display the bind information as shown in the figure:
device will send a binding request. Then operate the control device within 16 seconds to make it
also send a binding request. If the binding is successful,
the LCD will display "GOOD" as shown in the figure:
seconds and then return to the main screen.
Display power consumption 10.5 kW.
icon will flash once, at this time the LCD value
,and the
It will flash for 3