Table of Contents
Advertisement
5. Setting up Z308
5-1. Turn On/ Turn Off Z308
To manually turn on or turn off Z308, please use the following instructions:
A. Turn it on: Press and hold the Panic Button for 3 seconds. The indicators will flash once, and the
device is ready to be used.
B. Turn it off: Press and hold the Panic Button for 6 seconds. The indicator will flash
within 5 seconds. Within the 5-second period of time, press the Panic Button again to turn it off.
5-2. Join the ZigBee Network
After Z308 is turned on, it will search for an existing ZigBee network and send a request to join the network
automatically. While Z308 is under the coverage from a coordinator or a router whose permit-join feature is
enabled, Z308 will be permitted to join the network.
Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to
the user manual of the coordinator or the router to enable the permit-join feature).
Step2. Turn on Z308. It will start to search and join the network.
Step3. The indicator will flash
Step4. The indicator will flash
not flash.
Step5. When Z308 cannot join a network in 25 seconds, it will go into turn-off mode.
After joining a network, Z308 would try to enroll in the ZigBee security system. Please make sure Z308
and CIE (Control and Indicating Equipment) device have enough power.
5-3. Enroll in the ZigBee Security System
Z308 is a Zone device in the ZigBee security system. Right after Z308 join the ZigBee network, it will
automatically find out a CIE (Control and Indicating Equipment) device (i.e. Netvox Z201B) and send a
registration request to the CIE device to enroll in the security system. The enrollment has these 3 situations:
A. There is no CIE device or no compatible CIE device in the network → the indicator flashes
B. There is a compatible CIE device in the network, but it is failed to enroll → the indicator flashes
times. Users can reboot Z308 to initiate the registration.
C. The enrollment is completed → the indicator flashes
NOTE: Users had better NOT enroll multiple Zone devices at the same time to prevent registration failure.
When ZB02C is in a ZigBee network → the indicator will flash
green
green
once when it finds out a network to join.
5 times after it is joined successfully. Otherwise, the indicator will
red
6 times.
6
green
5 times.
red
10 times
red
twice.
red
4
Advertisement
Table of Contents
