1. Introduction RA07W is a ClassA type device based on the LoRaWAN open protocol of Netvox and is compatible with the LoRaWAN protocol. It is the long-distance wireless device for locating the leakage position. LoRa Wireless Technology: LoRa is a wireless communication technology dedicated to long distance and low power consumption. Compared with other communication methods, LoRa spread spectrum modulation method greatly increases to expand the communication distance.
2. Appearance Indicator Function Key 3. Main Feature Compatible with LoRaWAN Adopt SX1276 wireless communication module DC 12V adapter power supply Protection level: IP65 Detect the water contact position of the leakage detection line Locate the leakage position ...
5. Set Up Instruction On/Off Power ON RA07W are connected to DC 12V adapter for power on. Turn On Connect with power on to turn on. Restore to Factory Setting Press and hold the function key for 5 seconds and the green indicator flashes 20 times.
*The current sampling cycle is 1s. The positioning data may be deviated when just soaked in water, and then the value will stabilize after 5s. The device reported data parsing please refer to Netvox LoraWAN Application Command document and Netvox Lora Command Resolver...
7. Installation 1. RA07W is fixed with screws (purchased by self), and the device is fixed to the wall or other surface (as the figure below). Note: Do not install the device in a metal shielded box or in an environment with other electrical equipment around it to avoid affecting the wireless transmission of the device.
Page 10
(susceptible to interference) (susceptible to damage cable) (damp to false alarm ) Report time: real time (within 10 seconds) RA07W Fixed hook Detection wire 检测线 Water Soaking depth > 2mm >5cm Soaking water >...
8. Important Maintenance Instruction The device is a product with superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture and various liquids or water may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.