If the binding fails, the LCD will display fail as shown in the figure:
flash for 3 seconds and then return to the main screen. After the binding is successful, you can control
the device Z810B to change the switch and level.
(b) Unbind: If the binding operation is performed on the already bound device, it will be unbound.
Note: The device supports 16 Banding tables, 16 Group tables and 16 Scenes tables.
4.4 Controlled
Binding control: Send switch/level commands through the bound control device to control the switch
loaded on the Z810B.
4.5 Direct control
The LCD will display the
4.6 Allow joining the network function
As a router in the network, Z810B has the function of allowing other devices to join the network as its
sub-devices. Simultaneously press the binding key and the function key for 1 second, the icon
flash once, after releasing the key, the LCD value area will display JOIN, and return to the power display
screen after 1 second, and the unlock icon
picture:
14 End Devices.
icon when the relay is working, otherwise it will not display.
will start flashing , and flashes 60 times. As shown in the
It is allowed to join the network for 1 minute. The device can connect up to
It will
will