Compass C-PILOT EVO User Manual page 12

Compass s.r.l. User manual C-Pilot PRO
In-flight use
C-Pilot EVO was designed so that it requires very few inputs from the pilot while flying. This was one
of our main targets right from the start of the development of the device. We wanted it to be very
easy to use, but, more importantly, we wanted to guarantee the maximum safety for you, by
avoiding any unnecessary distraction. C-Pilot EVO manages automatically the displays (we shall
see later how to design them, on page 49), by showing the one that you have chosen for the specific
flight situation you are in. It manages automatically the turnpoints of a task, and also optimizes the
magnification of the map so that you always see your next turnpoint. Simply touching on the map the
waypoint the pilot desires to navigate to, can launch a "GOTO".
Manual/Automatic selection of the displays
You can disable (or enable again) at any time the automatic selection of the display and manually
select one among those stored in C-Pilot PRO by pressing the central button in the control bar.
If the display selection is in automatic mode, this is shown by the icon:
While the manual-selection mode is indicated by;
When you press the central button, that indicates the name of the actually selected display, the list
of stored displays will be shown (Figure 3). By selecting a display from the list and pressing the "ok"
button, the selected display will be loaded and the manual display selection will be activated. The
automatic selection can be restored by pressing the "auto" button. "Cancel" closes the display-
selection page without changing the currently-active setting.
The display-selection page will disappear automatically in ten seconds.
Warning: while the Manual mode is activated, the instrument will not automatically switch into the
Thermal mode (thermal assistant page) or into other automatic configurations of the display (start,
goal, airspaces )
8
Errore. Lo stile non è definito.