Compaq 5525B/31/32 User Manual page 112

Chapter 8
Complete Command List
set sysinfo descramblekey hexvalue
set sysinfo descramblekey 1234
Set the key value used for descrambling print jobs that have passed
through Printronix npscramble utility on a TCP/IP host. This key is a
four-digit hexadecimal value obtained from the host software,
npscramble. Within the npscramble source code, there is a variable
called SR_KEY which contains the default key value. This can be
changed to any four-digit value you would like.
set sysinfo module [[-]novell] [[-]netbios]
set sysinfo module -novell
Enable and disable certain network protocol stacks within the
PrintNet. Sometimes it helps to disable any protocols you are not
using on your network.
set time hours [ minutes [ seconds ]]
set time 10 30
Set the current time noting the hours based on the 24-hour system
and the minutes and seconds ranging from 0 through 59. If the
PrintNet is reset, this value will be lost so you will need to set the time
again.
set user add|del username
set user add eng
Add or remove a user on the PrintNet defined by username.
IMPORTANT
Be careful not to delete the root user, or you will be unable to
configure any further settings on the print server. You will have to
go back to factory defaults to correct this problem.
set user passwd username password
set user passwd eng mplex1
Assign a password to a defined user on the PrintNet. This password
must be less than eleven characters.
set user type username root|guest
set user type eng root
Assign root or guest privileges to a particular user defined by
username . Guest permissions allow viewing of settings only. Root
permissions allow complete control of the PrintNet.
112