Compaq 5525B/31/32 User Manual page 108

Chapter 8
Complete Command List
email
syslog
set logpath from default
Set all logpath settings back to factory defaults.
set logpath from stored
Set all current logpath settings to the values stored in flash memory.
set model model name newname
set model m1 name landscape
Change the current name of the model to a new name as indicated
by newname . This newname must be nine characters or less or it
will be truncated. These names are case sensitive.
set model model type raw
set model m2 type raw
Set the model type to raw so that it does not process the data
passing through it in any way.
set model model banner [ps|text|auto [after]]
set model m2 banner text
Determine whether a banner page should be added for print jobs
passing through the model mapped destination/queue. auto will
determine which type is needed depending on the type of print job
data passing through. By default, banner pages are added to the front
of the job. If after is set, the banner page will come at the end.
set model model stty [[-]onlcr] [[-]descramble] [xtab
tablength |none]
set model m3 stty onlcr
Control extra job processing done by the model . The processing
options are:
onlcr
108
Particular user's email address. This address is set
using the "set sysinfo email
emailname@IPaddress " command.
A central TCP/IP host running the SYSLOG
daemon. This host is set using the "set sysinfo
syslog IPaddress " command.
Carriage return insertion for Unix text jobs. Adds
carriage returns to text jobs with solitary linefeeds.
This will prevent stair-stepped output or output
running off the right side of the page.