Speakers; Removing The Speakers - Alienware m16 R1 Service Manual

Steps
1. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x2.5) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the I/O board cable to the palm-rest and keyboard assembly and adhere the tape to secure the I/O board cable.
4. Connect the power-button cable and close the latch to secure the cable.
Next steps
1. Follow the procedure from step 1 to step 8 in
NOTE: The system board can be removed and installed along with the fan and heat sink. This simplifies the removal and
installation procedure and avoids breaking the thermal bond between the system board and heat sink.
2. Install the 2230 solid-state drive
3. Install the 2280 solid-state drive
4. Install the rear-I/O cover.
5. Install the small fan.
6. Install the top heat-sink
7. Install the wireless card.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in

Speakers

Removing the speakers

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
Installing the system
in slot three and four.
or 2230 solid-state drive
After working inside your
Before working inside your
board.
in slot one and two, whichever applicable.
computer.
computer.
35