Table of Contents
Advertisement
Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then
place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when
the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a
component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Base cover
Base cover
2280 or 2230 solid-state drive
in SSD Slot one and two
2230 solid-state drive in SSD
Slot three and four
Wireless-card bracket
Small fan
Rear I/O cover
Rear I/O cover
I/O board
Battery
Screw type
M2.5x8 (captive screw)
M2.5x5
M2x3.5
M2x3.5
M2x2.5
M2x4
M2x4
M2.5x5
M2x2.5
M2x3.5
Quantity
2
6
2
2
2
3
5
2
4
4
Screw image
9
Advertisement
Table of Contents
