Dual Spray System (Oct 2020) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

Section 2. Safety Information

2.3 Dual Spray System (Oct 2020)

Overview
● Q-SUN Xe-3 models equipped with dual spray (DS) have a separate assembly, which includes the fluid reservoir and
an enclosure housing an electrically operated pump system
Electrical Shock Hazards
● Because the Dual Spray system is electrically operated, care should always be exercised when working on or around
the equipment, particularly if the floor is wet.
● The enclosure below the reservoir houses the system pump and other components, and should only be opened by
trained service technicians.
Fluid Hazards
● The fluid being introduced into the Q-SUN by the Dual Spray system is determined by the customer's application and
fluid specifications are beyond the scope of this manual.
● Fluids that may be corrosive, acidic and/or toxic may be introduced into the Dual Spray system.
● Follow all local, OSHA, EHS, and other applicable material handling safety requirements, recommendations, and
practices when mixing, refilling, and disposing of these fluids.
● The Dual Spray reservoir and all containers used in conjunction with fluid storage should be properly labeled.
● Some fluids which may be used in the reservoir of the Dual Spray system can become contaminated with fungus,
bacteria, or other organisms.
● Depending on the fluid used, frequent checks and cleaning of Dual Spray components may be required
(see Section 15.5).
● Consideration should be given to mixing small batches of liquid frequently rather than large amounts that could
become contaminated before use.
8
Reservoir
Pump
Enclosure
Figure 2.3: Dual Spray reservoir and pump system enclosure.
(Figure 2.3).