Q-Sun Xe-3-H Control Panel (May 2020) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

Section 6. Start Up

6.3 Q-SUN Xe-3-H Control Panel (May 2020)

● The power switch is located on the tester control panel
● The keypad is used to enter all input required for tester operation
● The status and message display shows keypad input as well as diagnostic information and messages.
● The test monitor displays show test setup parameters and provides real-time data on actual test conditions
(Figure 6.3d and
Actual:
Elapsed:
50 50
Figure 6.3e).
Figure 6.3a: Power switch on Xe-3-H control panel.
?
Program
Escape
Figure 6.3b: Xe-3-H keypad.
Status
Message
Figure 6.3c: Xe-3-H status and message display.
Irradiance
W/m @ Control Wavelength
2
Set:
Lamp Lamp Lamp
1 2 3
Figure 6.3d: Xe-3-H irradiance, temperature and relative humidity display.
Step Time
Hours: Minutes
Set:
Figure 6.3e: Xe-3-H step time, test time, and total time display.
(Figure 6.3a).
(Figure
Silence Clear
Enter RUN STOP
o
Temperature
nm Black
Panel
Test Time
Hours: Minutes
Elapsed:
Set:
6.3b).
Alarm
Irradiance
Calibration
C RH
%
Chamber Relative
Air Humidity
Total Time
Hours Elapsed
kJ/m 2
kJ/m2 Elapsed
(Figure 6.3c).